Grab adhesive SX 100 – for polystyrene & PU mouldings, 490g cartridge
The grab adhesive SX 100 is suitable for fixing decorative mouldings, ceiling roses, ceiling arches and PU ceiling beams in interior areas. It is solvent-free, formaldehyde-free and based on a dispersion formula. The adhesive adheres to absorbent, firm substrates and can also be used for grouting at butt joints or mitres.
The adhesive is suitable for expanded and extruded polystyrene as well as polyurethane. Application is done in dots or strips with a cartridge gun. The component is pressed into the still-moist adhesive. Fresh adhesive residues can be removed with a damp cloth.
The recommended application temperature is between 15°C and 25°C. After use, the cartridge cap should be cleaned so that the contents can be reused. For clean application, a stable cartridge gun is recommended.
Safety and mandatory information
Product type: Assembly adhesive based on plastic dispersion. Solvent-free, formaldehyde-free, water-based (VOC approx. 0.54 %).
Safety instructions:
- Keep out of reach of children.
- Avoid contact with eyes and skin.
- Do not eat, drink or smoke while working.
- In case of eye contact, rinse immediately with plenty of water for at least 15 minutes; seek medical advice if irritation persists.
- In case of skin contact, wash with soap and water.
- If swallowed, rinse mouth with water and consult a doctor.
- Ensure good ventilation.
Water hazard class: WGK 1 (slightly hazardous to water). Always observe the information on the product label.