Polystyrene adhesive SX 20 – polystyrene filler adhesive
The polystyrene adhesive SX 20 is suitable for bonding and grouting decorative profiles and mouldings made of polystyrene or polyurethane in interior areas. It is based on a solvent-free dispersion formula and is free from formaldehyde. The adhesive is paintable with acrylic or water-based paints and forms a smooth, sandable surface after drying.
Application and use
The open time is approximately 20–25 minutes. After around 24 hours, the adhesive is surface-dry; after about 40 hours, it is fully cured. It is applied in dots or strips – to dry, clean and firm substrates. The mouldings are pressed on while still moist; excess adhesive can be removed while still wet.
Suitable for butt joints, mitre cuts and also for large-area filling. Tools can be cleaned with water after use. The recommended application temperature is between 15°C and 25°C.
Safety and mandatory information
Product type: Assembly adhesive based on plastic dispersion. Solvent-free, formaldehyde-free, water-based (VOC approx. 0.54 %).
Safety instructions:
- Keep out of reach of children.
- Avoid contact with eyes and skin.
- Do not eat, drink or smoke while working.
- In case of eye contact, rinse immediately with plenty of water for at least 15 minutes; seek medical advice if irritation persists.
- In case of skin contact, wash with soap and water.
- If swallowed, rinse mouth with water and consult a doctor.
- Ensure good ventilation.
Water hazard class: WGK 1 (slightly hazardous to water). Always observe the information on the product label.