Transition Strip in Black-Look with Height Compensation
The transition strip in black-look bridges height differences between two floor coverings of 0 to 17.5 mm. With a width of 48 mm and a build-up height of around 10 mm, the strip spans wider gaps securely. Fitting is concealed using hammer-in wall plugs, so no screw heads remain visible after installation. This variant has a length of 1,900 mm.
Powder-Coated Aluminium in Matt Black
The strip is made of aluminium with a matt powder coating in deep black. The surface reflects almost no light, shows noticeably less dust than glossy variants, and is scratch-resistant and easy to maintain. A damp cloth is enough for cleaning.
Fitting with Concealed Hammer-In Wall Plugs
The strip is not pre-drilled. To fit, drill holes into the substrate using a 6 mm masonry drill bit, insert the hammer-in wall plugs and drive them in firmly with a hammer. The wall plugs are not included. No screw heads are visible after installation. The drill should be held at a right angle so the strip later lies flat.