Transition Strip in Stainless-Steel-Look with Height Compensation
The transition strip in stainless-steel-look bridges height differences between two floor coverings of 0 to 17.5 mm. With a width of 48 mm and a build-up height of around 10 mm, the strip spans wider gaps securely. Fitting is concealed using hammer-in wall plugs, so no screw heads remain visible after installation. This variant has a length of 950 mm.
Anodised Aluminium in Stainless-Steel-Look
The strip is made of anodised aluminium with a stainless-steel-look finish. The anodised surface is scratch-resistant, corrosion-resistant and easy to maintain. Compared to genuine stainless steel, aluminium is noticeably lighter and easier to cut to size without losing stability. Clean with a damp cloth.
Fitting with Concealed Hammer-In Wall Plugs
The strip is not pre-drilled. To fit, drill holes into the substrate using a 6 mm masonry drill bit, insert the hammer-in wall plugs and drive them in firmly with a hammer. The wall plugs are not included. No screw heads are visible after installation. The drill should be held at a right angle so the strip later lies flat.